Moulinex JU5708 Mode D'emploi page 11

DESCRIPTION OF THE APPLIANCE
A
Large pusher
D
Feed tube
E
Cover
F
Sieve
G
Juice collector
H
Pouring spout
I
Pulp collector
J
Clamp
BEFORE USE
- We recommend that you wash the removable parts (parts A, E, F, G, I, P & Q) after unpacking the appliance
(see chapter
CLEANING AND CARE
- Unpack the appliance and then place it on a flat, stable work surface, slip back the clamp (J), remove the
cover (E), take out the protective card on the sieve (F) then remove the sieve (F) and the juice collector
(G).
STARTING
1
2
).
- Fit the pulp collector (I) on the rear of the appliance, tipping it forward
slightly to slide the collector under the safety device. The pulp collector
must be correctly positioned otherwise the machine will not operate.
- Fit the juice collector (G) in the appliance, tipping it slightly forward to
pass the pouring spout (H) through the hole provided.
- Place the sieve (F) in the juice collector (G). Ensure that the sieve is
correctly clipped onto the drive shaft (L) (audible click).
- Fit the cover (E) on the juice collector (G), ejection spout to the rear.
Switch (1 or 2 speeds according to model)
K
Drive shaft
L
Motor unit
M
Cord-tidy
N
Brush
O
Juice jug (according to model)
P
Foam separator (according to model)
Q
7