Monacor HDMS-201 Notice page 2

HDMI TM Switcher
GB
Please read these operating instructions carefully prior to
operating the unit and keep them for later reference.
1 Applications
Via this HDMI TM switcher two players with HDMI
connected to a reproducer with HDMI
switch between the players automatically and manually.
The switcher is compatible with the standard HDMI
Deep Color.
HDMI TM : High Definition Multimedia Interface = Multimedia inter-
face for signals of high resolution
2 Safety Notes
The units (switcher and power supply unit) correspond to
all required directives of the EU and are therefore marked
with .
WARNING The power supply unit is supplied with haz-
ardous mains voltage. Leave servicing to
skilled personnel only. Inexpert handling or
modification of the unit may cause an elec-
tric shock hazard.
G
The units are suitable for indoor use only. Protect them
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
Do not set the switcher into operation, or immediately
disconnect the power supply unit from the mains socket
if
1. there is visible damage to the power supply unit or to
the switcher,
2. a defect might have occurred after a drop or similar
accident,
3. malfunctions occur.
The units must in any case be repaired by skilled per-
sonnel.
G
For cleaning only use a dry, soft cloth, never use chem-
icals or water.
G
No guarantee claims for the units and no liability for any
resulting personal damage or material damage will be
Player 2
Player 1
®
HDMS-201
TM
TM . It is possible to
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
Copyright by MONACOR INTERNATIONAL. All rights reserved.
©
Order No. 06.7890
accepted if the units are used for other purposes than
originally intended, if they are not correctly connected
or operated, or not repaired in an expert way.
If the units are to be put out of operation defini-
tively, take them to a local recycling plant for a
can be
disposal which is not harmful to the environment.
TM
3 Connection and Operation
1) Connect the players to the jacks "Input 1" and "Input 2"
and the reproducer to the jack "Output". The figure
below shows an example of connection.
2) For long HDMI
supplied power supply unit to the jack "DC 5 V" and to
a socket (230 V~/ 50 Hz). For short cables the power
can be supplied via one of the connected units (to be
tested, if required).
3) As soon as a player is switched on, the HDMS-201
automatically switches to the unit switched on and the
corresponding indication of the HDMS-201 lights up.
4) If both players are switched on, it is possible to switch
between the units with the button "Select".
5) If the switcher is not used for a longer period of time,
disconnect the power supply unit from the socket, oth-
erwise a low current will permanently be consumed.
4 Specifications
Input jacks and output jack: . . . HDMI
Power supply: . . . . . . . . . . . . . . via connected HDMI
Dimensions: . . . . . . . . . . . . . . . 87 × 18 × 45 mm
Weight: . . . . . . . . . . . . . . . . . . . 142 g
Subject to technical modifications.
Power supply unit
230V~
TM cables (longer than 5 m) connect the
TM jack type A, 19-pole
plied power supply unit connected
to 230 V~/ 50 Hz
Reproducer
HDMS-201
Output
DC5V Input 2
A-1244.99.01.05.2011
TM unit or sup-
Select
Input 1