Maintenance; Changing Fuse; General Maintenance - Ryobi P131 Manuel D'utilisation

Chargeur de 18 v à nickel-cadmium et lithium-ion pour vehicule
Masquer les pouces Voir aussi pour P131:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
BATTERIES
This charger will accept Ryobi One + 18 V lithium-ion batteries
or Ryobi One+ 18 V nickel-cadmium batteries. Length of
service from each charging will depend on the type of work
you are doing.
Batteries have been designed to provide maximum trouble-
free life. However, like all batteries, they will eventually wear
out. Do not disassemble battery pack and attempt to replace
the batteries. Handling of these batteries, especially when
wearing rings and jewelry, could result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
For lithium-ion batteries:
 Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is below
80°F and away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as
normal.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 9
AFTER SPANISH LANGUAGE SECTION.

MAINTENANCE

WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.

CHANGING FUSE

See Figure 4, page 9.
The 12 V adapter contains a 250 V 8 Amp fuse to protect
the adapter and charger from unexpected power surges.
To replace the fuse:
 Unscrew the fuse cap on the top of the 12 V adapter.
 Replace old fuse with new one. If spring comes out, be
sure to reinsert it before replacing new fuse.
 Thread fuse cap back onto adapter. Tighten securely.
For nickel-cadmium batteries:
 Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is below
80°F.
 Store battery packs in a "discharged" condition.
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion and nickel-cadmium batteries must
be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/
or serious injury.
8 — English
WARNING:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

140126001

Table des Matières