Cleaning And Maintenance - Reer PMR 446 Mode D'emploi

2dans1 babyphone et talkie-walkie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Call

Briefly press

button.

The device will send ringtone to all other devices within reach on this channel. You can select

the ringtone in the selection or turn it off.

Warning: calling function is availavle only in the „PMR446" operating mode.

Keypad lock

All buttons except for PTT button can be turned off, to prevent accidental re-setting.

Locking buttons: Press and hold

symbol appears.

Unlocking buttons: Press and hold

button lock symbol disappears.

VOX as hands-free

This is the sensitivity setting for hands-free. The device automatically recognizes when you

speak - you don't need to press the PTT button. This can be useful at a moment when your

hands are not free to press the PTT button.

Levels 1-4 correspond to the same sensitivity levels as under the „baby monitor" operating

mode.

oF VOX is deactivated; normal operation with the help of PTT button (standard setting)

1. low sensitivity

2. medium sensitivity

3. high sensitivity

4. highest sensitivity

Monitoring functions

For reception of very weak signals, it is possible to deactivate automatic noise gate. This may

be useful in the border area of reception or when communication is faulty. Besides this, you

can easily listen to what is going on on the selected channel. To activate or deactivate moni-

toring functions, hold down MON button (on the left side of the device under the PTT button)

for a long time. Monitoring function is available only in the „PMR446" operating mode.

Roger-Beep

The device can broadcast a tone sequence after releasing the PTT button.

Press the

button 5×, until rb appears on the display.

Press /, by which you will set on or oF.

For saving settings, briefly press the PTT button.

button for roughly 3 seconds, until the button lock

button once again for roughly 3 seconds, until the

When Roger Beep is activated, the

appears. Roger Beep is available only in the „PMR446"

operating mode.

Button tone

When pressing the buttons, a short signal tone sounds. For turning the sound of the buttons

on or off:

Press the

button 6×, until bP appears on the display.

Press /, by which you can choose on or oF.

For saving settings, briefly press the PTT button.

When the key sound is activated, the symbol

„PMR446" operating mode.

Range control in PMR446 operating mode

choose between AU (automatic), Pb (only manual range control) or oF, by which you will

turn offthe range control function. Activation or deactivation of range control is done on the

device on which you wish to effect range control. Even if the range control function is deac-

tivated on another device, you can undertake range control on your device..

In radio networks that consist of more than 2 of the same device, there is no sense in range

control because it is not possible to determine which device corresponds to it. This is why no

reach control exists for multiple devices in network.