Bosch CM8S Consignes D'utilisation/De Sécurité page 45

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 45
▶ Special Cuts
operation. Before switching on, lower head
assembly to make sure clamp clears guard and
head assembly.
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
hand to saw blade, extend the sliding fence and
base extensions when making extreme bevel,
miter or compound cuts.
▼ CUTTING BOWED MATERIAL
▼ CUTTING ROUND OR IRREGULARLY SHAPED
MATERIAL
Saw Operations
Use clamping position that
does not interfere with
Be aware of the path of the
saw blade. Make a dry run
To provide sufficient
(minimum 6") spacing from
FIG. 52
Clamp
Sliding
Fence
Bowed Material
FIG. 53
Clamp
Sliding
Fence
Round Material
45
No Gap at
This Point