Publicité
Les langues disponibles
Les langues disponibles
If you place the kettle on the base plate, the LED display now shows the current
ACTUAL temperature of the water in the kettle (display min. >= 0°C ). If the device
is not used for 5 minutes, the display switches off automatically. The display can be
reactivated by pressing any key, or by simply lifting and placing the kettle from the
base. A control panel is located at the top of the handle. Press the „+" and „-" but-
tons and select your desired temperature. Alternatively, you can directly select the
temperatures 40/60/80/100°C with the „SET" button and correct it with the „+" and
„-" buttons. Press the „Start" button in order to start up the device (a short beep will
sound) and it is indicated by the dot above the temperature display on the display.
Once the water reaches the set temperature, you will hear a long beep signal. The
heating element switches off automatically and the boiling process is stopped. The
appliance can now be lifted and the water can be used. If you want to stop the
boiling process early on, you can press the "start" button at any time.
Before reaching the target temperature, the kettle interrupts the heating process
in order to carry out an intermediate measurement. Please wait until the boiling
process has been completed. An acoustic signal sounds at the end if the signal
tones are activated.
Note: If you press the „START" button directly when the display is switched on, the
device is started with the last set temperature!
5.1 Keep-warm function
The "KEEP WARM" function is intended to keep the boiled water warm for a long
period of time. Set your desired temperature with the "+" and "-" buttons. Press
the "KEEP WARM" button in order to start. The kettle activates the keep-warm
function for 30 minutes and maintains the set temperature. It is indicated by the
three dots above the temperature display on the display. Please note that the ket-
tle temperature heats up to temperatures above 90 °C, but that it can not keep
temperatures above 90°C while in keep-warm function.
5.2 Switching key signals on and off
You have the possibility to switch off the signal tones off the device or to reduce
them to the most necessary key tones. To do this, press the "Keep warm" and
"Set" buttons together. A short beep appears and means that the beeps are
switched on. If a long beep appears when the "keep warm" and "set" buttons are
pressed, the beeps of the device are switched off.
Press the "Keep warm" and "Set" buttons together, to switch the key signals on
and off.
22
English
Publicité
