Tritech T8 Mode D'emploi page 50

13. Fill gear box with # 2 lithium base grease.
14. Reconnect black and red cap/motor and transducer leads to circuit board in control box.
15. Complete reassemble in reverse order.
REPLACE GEARS/CONNECTING ROD
Follow pressurerelief procedurebefore attempting to serviceor repair unit.
If trouble shoo�ng guide suggests replacing the gears or connecting rod follow the directions
below.
1. Remove 4 screws #40 and remove cover plate #55.
2. Remove 4 screws #40 and remove cover plate #70.
3. Remove 2 screws #25 and unthread transducer # 30 (see diagram "A") and remove pump/filter
manifold.
4. Remove 4 screws # 54 then remove crank housing. Connecting rod can be replaced at this point.
5. The reducer gear #50 and crankshaŌ #51 can also be replaced at this point.
6. Complete reassemble in reverse order.
50