Tritech T8 Mode D'emploi page 49

7. Remove 2 screws #57. Make sure to firmly hold control box in place.
8. Remove tranducer by guiding the wire through the circuit board and out the back of the control
box.
9. Install new transducer by sliding the wire through grommet #91 and guiding the wire through
grommet #86 and continuing through the circuit board.
10. Connect tranducer to the circuit board and reinstall screws #57.
11. With needle nose pylers slider transducer into filter manifold making sure o-ring #88 stays in
place.
12. Tighten housing #90 and install cover plate #70 with 4 screws #40.
REPLACE ON/OFF SWITCH
Follow pressurerelief procedurebefore attempting to serviceor repair unit.
If trouble shoo�ng guide suggests replacing the on/off switch follow the directions below.
1. Remove 4 screws #40 and remover cover plate #70.
2. Disconnect the two leads from the on/off switch.
3. Remove mounĦng screws #78.
4. Remove switch indicator plate #79 and remove the on/off switch #80.
5. Replace in reverse order.
REPLACE MOTOR BRUSHES:
Follow pressurerelief procedurebefore attempting to serviceor repair unit.
If trouble shoo�ng guide suggests replacing the motor brushes follow the directions below.
1. Remove 3 screws #40 and remove cover #42.
2. Use a straight blade screwdriver to remove brush retaining cap to expose motor brushes.
3. Remove motor brushes #48 one at a Ħme. Inspect. Replace if worn or damaged
4. Reassemble in reverse order. When reinstalling motor brushes make sure to have red and black
wire leads to the back of the motor housing.
REPLACE MOTOR
Follow pressurerelief procedurebefore attempting to serviceor repair unit.
If trouble shoo�ng guide suggests replacing the motor follow the directions below.
1. Remove 3 screws #40 and remove motor cover #42.
2. Remove 4 screws #40 and remove cover plate #70.
3. Disconnect Black and Red cap/motor leads from circuit board #73. See diagram "D/E"
4. Remove 4 screws #40 and remove cover plate # 55.
5. Unthread Transducer housing # 90 and slide Transducer #89 back from Fluid Manifold.
6. Remove 4 screws #54 and remove crank housing and fluid manifold together.
7. Remove crankshaŌ #51 and thrust washer #52.
8. Remove reducer gear #50
9. Remove 2 screws # 57 from underneath. Leave 2 screws #57 that aŃach bracket #87 to control
box #92.
10. Remove 4 screws #96 see diagram frame and siphon tubes and separate motor complete from
frame.
11. Install reducer gear # 50 into gear box and rotate fan to insure armature shaŌ is engaged.
12. Install crankshaŌ and thrust washer #51, 52.
49