Kohler K-3180 Guide D'installation page 5

2-3/8"
(6cm) MIN.
1. Position the Template
- Cut the template following the lines marked "Cut on this line".
- Determine your desired installation location. Use the center lines
provided on the template to assist in positioning.
- Position the template on the countertop in the desired location. Make
sure the template is secured firmly in place so it cannot move.
- Check for adequate clearance between the sink, faucet and
backsplash. Verify that the sink will not interfere with the cabinet
during installation.
- Trace the outside edges of the template with a pencil.
NOTE For multiple sink installations, a minimum distance of 2-3/16"
:
(7.1cm) is required between the sinks.
- Locate the faucet hole center lines on the countertop. The faucet hole
clearance from the top of the cutout must be 2-3/8" (6cm) minimum.
2. Cut the Sink Mounting Holes
CAUTION: Risk of product damage. To avoid damage to the sink,
do not cut , drill, or sand the countertop while it is positioned over
the sink.
- Before cutting, measure the cut- out line and compare it to the
overall sink dimension. The cut-out should be 1-1/2" (3.8cm)
smaller than the overall sink dimensions.
- Drill a pilot hole inside the cut-out line.
- Using a saber or keyhole saw, cut along the inside of the cut-out line.
- Drill the required faucet holes and install the faucet to the
countertop according to the faucet manufacturer's instructions.
Kohler Co.
Faucet
Centerline
Cutting Line
5
C
1007258-2-