Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Dear customer,
Thank you for purchasing an ALFRA product. Please read these operation instructions closely before using
your device for the first time and keep them along with the enclosed Product Control Card for later reference.
SAFETY INSTRUCTIONS
Danger can occur when using extremely strong magnetic clamps due to improper handling and/or poor
maintenance, which may cause serious accidents with fatal physical injuries. Please read these operation
instructions closely and observe all safety instructions mentioned therein. If you have any questions, contact
the manufacturer.
!
Important
• stability and safe hold do not occur on round or arched surfaces
• use the magnetic clamp preferably on plane surfaces
• full performance is only reached when using the entire magnetic surface
• cavities or drilled holes underneath the surface reduce the magnetic holding force
• fixing several work pieces on top of each other decreases the holding force significantly
• ensure that the lever springs back strongly during work on thin materials
!
Always...
• activate the magnetic clamp completely
• activate the magnetic clamp on metallic,
ferromagnetic materials
• clean the magnetic surface and keep it clear
of dirt, chips and welding spatter
• set the magnet clamp down gently to prevent
damage to the magnetic surface
• respect the stated maximum breakaway force
• inspect the magnetic surface and the entire
magnetic clamp for damage
• follow the instructions in this operating manual
• instruct new operators in the safe use of
switchable magnetic clamps
• respect local and country-specific guidelines
on handling magnetic tools
• keep and use in a dry environment
People using pacemakers or other medical devices should not use this magnet until they
have consulted with their physician.
!
Never...
• exceed the stated maximum load
• use the magnetic clamp to lift or transport loads
• use the magnetic clamp to support, lift or
transport persons
• switch the magnetic clamp off before setting
down all work pieces in a safe end position
• modify the magnetic clamp or remove
operating labels
• use the magnetic clamp if damaged or
missing parts
• strain the underside of the magnet through
heavy impact or blows
• use the magnetic clamp without having been
properly instructed
• use if you have not read and understood these
operating instructions completely
• place fingers or any other body part between
the magnetic surface and the work piece
because there is a risk of injury
• operate in temperatures higher than 60°C (140°F)
• expose to corrosive substances
11
Publicité
Table des Matières
