GYM form SLIM FOLD TREADMILL PRO Mode D'emploi page 14

capabilities unless
supervised or instructed
someone responsible for their
safety.
- Children should be supervised
at all times to ensure they do not
play with the device.
- Do not use the device if you
weigh more than 120 kg.
- This device is designed for
individual use. Any breakdown
caused by improper use is not
covered by the warranty.
- Make sure the device is on a
flat surface. Do not use dangling
clothing on the treadmill and do
not scuff the treadmill, as this will
make it difficult to use. Wear sport
shoes when using the treadmill.
Do not start the treadmill while
standing on it. The best position
when switching on the device is to
stand with one foot on either side
of the treadmill. If the initial speed
of the treadmill is too fast, do not
jump on the treadmill. Start using
it at a lower speed and increase it
gradually.
- Do not suddenly stop walking or
running on the treadmill. Press the
ON/OFF button and the treadmill
will gradually stop.
- Stop walking when the treadmill
stops.
- Leave a safety area of 2 metres
by 1 metre behind the treadmill.
14
they are
by 1m = 3,28 feet
PRECAUTION: DO NOT remove
the cover of the control panel,
as this may cause an electric
shock. The parts inside cannot be
repaired by the user.
Product description
1. Control panel
2. Emergency key
3. Base
4. Treadmill belt
5. Vertical bar screw
6. Handlebars
7. Lock screw
8. Control panel screw
9. ON/OFF button
10. MODE button
11. Button
12. ↓ Button
13. ↑ Button
14. Function indicators
15. Allen key
16. Wheels
17. Vertical bars
18. Metal base
19. Base extension
20. Washers x 6
21. Screws x 6
22. Handlebar cable
23. Vertical bar cable
24. Screws x 2
25. Nuts x 2
26. Handlebar screws
27. Spanner
28. Pulse sensors
29. Belt screws
30. Incline part
31. Incline pin
Assembly Instructions:
1. Open the box, unpack all the parts and
take out the treadmill.
INSTALLING THE METAL BASE
2. Place the treadmill in the horizontal
position on a flat surface.
3. Use the vertical bar screw (5) to
connect the base (3) to the vertical bars
(17). Tighten the screw as much as you
can (Picture 3).
4. Raise the treadmill to the upright
position while making sure that the base
(3) is firmly attached to the vertical bars.
Attach the base extension (19) to the
metal base (18) with six washers (20)
and six screws (21) and the Allen key (15)
(Picture 4).
CONNECTING THE HANDLEBARS
5. Remove the vertical bar screw (5)
connecting the base (3) to the vertical
bars (17).
6. Gradually lower the base (3) until it is
resting on the floor.
7. Connect the handlebar cable (22) to
the vertical bar cable (23). See Picture 5.
8. Place the handlebars (6) on top of the
vertical bars (17) and attach them with
two screws (24) and nuts (25). Tighten
them with the Allen key (15) and spanner
(27). Ensure that they are firmly attached.
9. Attach the handlebars with the two
handlebar screws (26).