Sperian Miller TechLine HLLR Serie Manuel D'utilisation page 9

Step 1
Wrap cross-arm strap around
approved anchorage point. To
prevent slippage, wrap cross-
arm strap around anchorage
point as many times as possible.
D-ring must pass completely
through loop.
Step 2
Secure snaphooks on either
end of lifeline to D-ring
on cross-arm straps. Be
sure snaphook is attached
properly and no gate loading
is present.
Step 3
Remove slack in system by
releasing the tension release
lever and pull the free end of
the rope through the tensioner.
Step 4
Tension the line with wrench
or bar by pulling firmly on the
free end of the rope while
at the same time turning the
tensioner nut in the direction
of the arrow. Tighten nut
until tensioner begins to
slip against the rope. Once
slippage occurs, DO NOT
continue to tighten the
tensioner.
USER INSTRUCTI ONS - EN GLI SH
9