Speck pumpen BADU 90 Eco VS Fiche Technique page 16

POWER
Speed adjustable
1 2
INFO
POWER
Speed adjustable
1 2
INFO
Note: The speed cannot be changed during the priming phase.
16 EN VG 766.2100.071
3
S
0
3
S
0
Operation:
Press the button "1", "2" or "3" to select the
preset fixed speed.
If the pump starts from a standstill, it starts up
in priming mode (in as far as it is activated)
and subsequently with the selected fixed
speed.
As long as the pump is in the priming phase a
bar moves at the first position in the display
from the lower, through the middle to the
upper position.
During running operation the pump is started
up to the speed directly, without priming time.
The motor is stopped by pressing the button
"0". The "Power" LED flashes and the display
shows "oFF".
Setting the speeds
Press the button of the fixed speed that is to
be changed ("1", "2" or "3") and then change
the speed by using the "▲▼" buttons. The set
speed is stored directly and approached
immediately when the fixed speed is selected
again.
01/2014