Whittier Wood Products 314W Instructions De Montage page 4

C
4) Insert the Slats (C) into the holes in the bottom of the end aprons on the top assembly. DO NOT
GLUE THE SLATS.
5) Slide the leg assembly down over the top assembly so that the legs fit in the gap between the
aprons and slowly work the slats into the holes in the shelf supports. See FIGURE 4. When the
legs are flush against the top, insert a 3/8" x 2½" Hex Bolt (I) with a Washer (J) through the leg
support into the insert in the leg and fasten securely. See FIGURE 5.
LL
FIG. 6
6) Attach the Cup Pull (LL) to the drawer with two #8 x 1" Machine Screws (MM) through the holes in
the drawer front.
7) To eliminate pulling the drawer out too far, attach the Drawer Stop (P) with a #6 x 5/8" Flat Head
Screw (Q) to the top.
To determine the location, draw a line between the front edges of both drawer slides. Attach the
drawer stop so that its front edge is 1/2" from the line.
The loose end of the drawer stop may be pressed upwards to install or release the drawer.
Page 4 – 314W-319W
C
FIG. 4
MM
KK
P
Q
J
I
AA
DRAWER
SLIDE
Y
1/2"
FIG. 7
E
FIG. 5
DRAWER
SLIDE
X