Publicité
Les langues disponibles
Les langues disponibles
314W, 316W, 318W & 319W Mission Tables
ASSEMBLY INSTRUCTIONS
Phillips Screwdriver, Adjustable or 9/16" Wrench, Slotted Screwdriver,
WE RECOMMEND FINISHING THE UNIT BEFORE ASSEMBLY.
B
H
1) Glue two 3/8" x 1½" Wood Dowels (H) in each end of both Shelf Supports (B). Screw a Cam
Connector (N) into each hole in the wide edge of the shelf supports.
2) Glue a Shelf Support (B) dowels into the holes in a Right Leg (E) and a Left Leg (F) making sure
that the Cam Connectors (N) face the same direction as the inserts in the legs and the holes for the
slats in the narrow edge face up.
Repeat for the other shelf support and the remaining legs.
3) Attach the Shelf (DD) to the Shelf Supports (B) using the Cam Connectors (N) and Cam
Housings (O).
TOOLS REQUIRED:
Rubber Mallet or Padded Hammer, Wood Glue.
Before finishing, read enclosed finishing hints.
N
FIG. 1
O
IMPORTANT:
F
H
N
DD
FIG. 3
Holes for slats
should face up.
Cam Connectors
should face toward
center of table.
B
FIG. 2
O
314W-319W – Page 3
E
Publicité
