Alpine PXE-H650 Manuel page 7

WIRING/CONNECTIONS
Front Panel Chassis
1 USB Port - USB cable required for PC control/setup (PC software on supplied CD)
2 MULTEQ LED - Output for included LED; EQ Status indicator during setup
3 RESET - Press & Release button for: Clear settings, Factory Reset, or Redo MultEQ setup
Rear Panel Chassis
4 POWER SUPPLY Harness (6-Pin)
• Ground (BLK)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is
made to bare metal and is securely fastened using a sheet metal screw.
• Battery (YEL)
This is a constant +12V for the main unit. It will remain powered even when the Ignition
key position is OFF. It draws minimal current to maintain processor memory.
• Remote OUT (BLU/WHT)
This output can turn on external amplifi ers. The signal goes high after the PXE-H650
audio mute is OFF.
• Remote ON (BLU/WHT)
If the OEM head unit is not turning on the EQ using the AUTO RANGING INPUT,
use this wire. Connect this wire to the 'Auto Turn On' lead of the Factory head unit or a
switched 12 VDC source (Ignition).
• Remote Control (WHT/BRN)
This input provides a means by which an external source, connected to AUX, is controlled.
5 REMOTE IR INPUT (2.5mm mini-phono) - Input for external remote eye (included)
6 WIRED REMOTE INPUT (3.5mm mini-phono) - Input for steering wheel control (factory
option); Note: Using this input disables the factory head unit steering wheel controls.
7 AUX PRIMARY SOURCE - Turn this switch ON, if a factory radio source is not being used.
This accommodates an aftermarket radio using the AUX INPUT.
8 CLIP - This LED is ON whenever the AUX source is over the input limit.
9 AUX INPUT LEVEL - Use this trimmer control to adjust the AUX INPUT below clipping.
10 AUX INPUT - Use this input for an auxiliary source or an aftermarket head with line outputs.
11 MIC - 3.5mm T/S jack for included microphone
12 AUTO RANGING INPUT - Use this input for the factory head unit. This input is 'auto
ranging' to handle a wide range of factory head unit outputs. It will accept speaker or line level
outputs. It has 5 input pairs for Front & Rear Left +/-, Right +/-, and Subwoofer +/-.
13 RCA OUTPUT - 2 Front L/R Pairs, 1 Rear L/R Pair, 1 Subwoofer Mono
Front L1/R1
Front L2/R2
Rear L/R
Subwoofer
Note: OUTPUT: For full-range only, use outputs FRONT L2/R2
INPUT: If there is a L/R pair of full range outputs available from the factory system (FRONT or REAR)
these should be used fi rst and connected to inputs L2/R2 on the H650. If the factory 2-way
output must be used, connect Tweeter Left to L1,
Woofer Right to R2.
For Factory High-pass Output
For Factory Low-pass Output (or Full Range Output)
For Factory Rear, Full Range Output
For Factory Subwoofer Output
Woofer Left to ,
L2 Tweeter Right to R1, and
E
N
9