Cisco Systems Linksys WMP54G Guide D'installation Rapide page 6

3
Driver Installation and Configuration for
Windows XP
After installing the Adapter in your
computer, you will install the driver.
A
Windows XP will automatically
detect the Adapter. Insert the
Setup CD-ROM into your CD-
ROM drive. Click the radio
button next to Install the
software automatically
(Recommended). Then click
Next.
B
When Windows has finished
installing the driver, click Finish.
Windows XP has a built-in con-
NOTE:
figuration tool. Use Windows XP Wire-
less Zero Configuration (located in the
system tray at the bottom of your
screen) to configure the Adapter.
C
After installing the Adapter, the
Windows XP Wireless Zero
Configuration icon will appear
in your computer's system tray.
Double-click the icon.
Steps D and E are the instruc-
NOTE:
tions and screenshots for Windows XP
with Service Pack 1 installed. If you
have not installed Service Pack 1,
select the network you want, and click
the Connect button. If the network has
WEP encryption enabled, enter the WEP
key in the Network key field, and then
click the Connect button.
6
A
C