Brecknell MBS Serie Mode D'emploi page 10

Command
O
M
C
P
Change Print Settings
You can select either Continuous Print or Print When Stable.
1. Remove all weight (except platter) and power the balance off.
2. Power the balance on.
3. During countdown (9999.99, 8888.88, 7777.77), press the Mode key. The balance
displays F1 A2t.
4. Press the Mode key. The balance displays F2 prt.
5. Press the Tare key. The balance displays either Pt-0 (continuous print) or Pt-1
(bi-directional communication) Pt-1 is the default.
6. Press the Mode key until balance displays Pt-0.
7. Press the Tare key. The balance displays either PCon (print continuous) or PStb
(print when stable).
8. Press the Mode key to toggle between P2t6 and PCon.
9. Press the Tare key to accept the setting on the display.
10. Press the On/Off key when finished. The balance powers off and the changes
are saved.
11. Connect the balance to the printer or other device.
12. Power the balance on.
10
Table 1.1 Available Serial Commands
Response
Off
Displays the
Counts
Cal
Percentage
Command
T
F
U
W Return displayed
MBS Series User Instructions
Response
Tare
Mode
Units
weight