Beurer FC80 Mode D'emploi page 14

Skin compatibility test
Simply test the compatibility of the skincare
product so that you can be sure you will have
no skin problems.
> Clean a patch of skin in the crook of your
arm thoroughly with soap, apply a little of
the skincare product to this cleaned patch
of skin and allow the product to soak in
and dry.
Recommended treatment period and frequency
We recommend facial treatment a maximum
of 3 times per week for 10 minutes per
treatment.
Beginning the treatment
> Thoroughly clean the area to be treated
> Remove the transparent cover from the
ultrasound head
> Distribute some skincare product over
your face
Moving the ultrasound head
The movements of the ultrasound head over
the face should correspond approximately
to the natural lymphatic flow. Follow one
of the recommended sequences for facial
treatment.
• Put the ultrasound head on your skin.
Press the device down gently while you let
it glide over your face.
• Guide the device slowly from the centre of
your face outwards and from the bottom
of your face to the top.
• If the skin shows no reactions within the
next 48 hours, you can use the tested
product without hesitation.
• If skin reactions appear before the end of
the 48-hour period, you should not use the
tested product for facial treatment.
> Press the On/Off switch to switch the
device on
The green LED lights up.
• Lift the device as soon as you arrive at the
end of a movement and begin again at the
starting point.
• Always complete a cycle.
• Do not move the device back and forth.
• Move the device constantly during
treatment; do not hold it in one position for
long periods.
14