gdw 1212 Instructions De Montage page 5

Toyota Celica
12/1999 - ....
Ref. 1212
Fitting instructions
1) Remove both towing rings at the back of the vehicle and remove the 2 pellets in the screw-thread holes
(M8).
2) Fit mounting pieces (-g) and (-h) against the bottom of the chassis beam, with points (A) and (B) on the
provided screw-thread holes (see photo 1).
Insert bolts and washers but do not tighten anything. Loosen the bumper at the bottom at both lips. Bring
the tow bar with (C) and (C') between mounting pieces (-g) and (-h) on points (C) and (C'). Insert bolts
and tighten everything firmly.
3) At the ball T44 make an incision in the middle of the bumper as on sketch enclosed.
With the T36 don't make an incision in the bumper.
4) Assemble (*) and fasten firmly.
Composition
1 tow bar referecne 1212
1 ball T44M000
2 bolts M8x30
4 bolts M10/1,25x35
2 bolts M12x35
2 bolts M12x35 + moeren
2 bolts M12x70
2 security nuts M12
2 washers 25x8x2
2 security washers 8mm
4 security washers 10mm
4 security washers 12mm
1 mounting piece (-g)
1 mounting piece (-h)
1 security shackle (800053)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(B)
(A)
(C')
(C)
(*)
(*)
(B)
(B)
(A)
(C-C')
(C)
(C)
(*)
All bolts and nuts : quality 8.8