3M 26878 Manuel D'utilisation page 15

GENERAL SET UP AND SPRAY GUN USE - PRESSURE
Note: Complete steps below before connecting spray gun to air source�
Attaching the Atomizing Head
1� Pull trigger back and hold�
2� Slide the atomizing head over the fluid
needle and push towards the spray gun
body making sure locking collar is in the
"+ configuration" with locking lugs at the
counter clockwise stop at 3 and 9 o'clock�
3� Secure the atomizing head by rotating the
retainer ring, clockwise until the retainer ring
tabs are locked in the "X configuration"�
Removing the Atomizing Head
1� Fully pull trigger back and hold�
2� Rotate the locking collar counter-clockwise
3� Pull the atomizing head away from the gun
body to remove�
13 13