AUTO-HAK O52 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
4
A
7
6
This towbar is designed
TOYOTA COROLLA ESTATE CAR produced since 01.2002 till 2007,
catalogue no. O52 and is prepared to tow trailers max total weight 1350 kg and
max vertical load 55 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 12 - 85 Nm
4
D
C
8
7
5
1
3
to assembly in following
From manufacturer
M 10 - 55 Nm
M 14 - 135 Nm
1. Disassemble the rear bumper together with the plastic part.
2. Unscrew the towing eye and metal bumper reinforcement.
B
3. Disassemble the silencer and thermal plate.
4. Position the element (pos. 1) together with the towing eye to the car frame (do
it such a way that towbar holes pos. A and B cover original holes) and fix it
using bolts M12x1,25x40mm (pos. 6).
5. Slide the special nuts M10 (pos. 4) (do it such a way that the nuts cover the
6 holes pos. C) and fix it using M10x35mm (pos. 7).
6. Reassemble the thermal plate (use three original bolts but the fourth one which
is positioned at hole pos. D is from the towbar equipment M6x25mm – pos. 8).
7. Reassemble the silencer and plastic part after cutting it according to the fig. 1
and 2.
8. Tighten all nuts and bolts according to the torque shown in the table.
9. Position the ball of towbar (pos. 2) with socket plate (pos. 3) and fix with
M12x75mm (pos. 5) screws from the towbar accessories.
16
10. Connect the electric wires according to the instructions of the car.
11. Complete the paint cover of towbar (during the mounting paint cover could be
destroyed).
2
Fig.1
car:
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km of exploitation check all bolts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Fig.2
50
NOTE
CUT