AUTO-HAK O49 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
8
7
8
B
This towbar is designed to assembly in following cars:
TOYOTA AVENSIS VERSO, 5 door, produced since 04.2002, catalogue
no. O49 and is prepared to tow trailers max total weight 1500 kg and max
vertical mass 60 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
A
8
1
6
2
3
From manufacturer
1. Disassemble the bumper.
7
2. Unscrew the muffler.
5 3. Apply the main bar of the towbar (pos. 1) to the automobile frame, that way so
holes of the towbar (pos. A) be covered with factory-made threaded holes. Fix
4
using bolts M12x1,25x35mm (pos. 8).
4. Through holes (pos. B) fix with factory-made holes. Use distance sleeves
ø25xø13mm, L=23mm (pos. 4), washers ø41xø13x3mm (pos. 5) and bolts
M12x60mm (pos. 7) as showed on the fig. 1.
5. Screw on the muffler.
8
6. Install the bumper after the previous cut out of its fragment, see fig. 2.
Fig. 2
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm (pos. 6)
from accessories.
8. Tighten all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station).
Fig. 1
10. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
32
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE