AUTO-HAK O75A Instructions De Montage

FITTING INSTRCUTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
M12x40
M12x1,25x40
This towbar is designed to assembly in following cars:
TOYOTA RAV-4, model with the spare wheel, produced since 2009,
catalogue number O75A and is prepared to tow trailers max total
weight 2000 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installed in points described by a car producer.
4
M12x1,25x40
1
M12x25
13
3
1. For the purpose of installing of the towbar it is not necessary
to disassemble the bumper.
2. From the bottom of chassis members are factory-made
assembly holes. One ought to fix to them side brackets of the
towbar (pos. 4 and 5) using bolts M12x1,25x40mm (pos. 8) –
loosely.
3. Slip the main bar of the towbar (pos. 1) between brackets
(pos. 4 and 5) and fix using bolts M12x40mm.
4. Fix body of the automat (pos. 13) together with socket plate
(pos. 3) using bolts M12x25mm (pos. 6) from accessories.
Place tow-ball (pos. 2) according to supplied instruction.
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-poles socket according to the
12
instruction of the car. (Recommend to make at authorized
service station).
7. Complete paint layer damaged during installation.
2
M6 - 11 Nm
M 12 - 87 Nm
After install the towbar you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball
of towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
M 10 - 50 Nm
M16 - 210 Nm