DeWalt DCP580 Traduction De La Notice D'instructions Originale page 39

Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
e
designated D WALT chargers. Charging
e
battery packs other than the designated
D WALT batteries with a D
e
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Planer
1 Parallel fence
1 T25 star key
1 Gauge plate
1 Dustbag (kitted models only)
2 Li-Ion battery packs (kitted models only)
1 TSTAK kitbox (kitted models only)
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (Fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Trigger switch
B. Lock-off button
C. Main handle
D. Rear shoe
E. Drive belt cover
F. Hole for rebate fence
G. Front shoe
H. Rebate fence tightening knob
I. Planing depth graduation
J. Planing depth adjustment knob/ front handle
K. Chip ejection port
L. AirLock connection
M. Blade storage knob
N. Battery
O. Battery release button
P. Fuel gauge button
INTENDED USE
Your planer has been designed for professional
planing of wood.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This planer is a professional power tool.
WALT
e
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
Your D WALT charger is double insulated
e
in accordance with EN60335; therefore
no earth wire is required.
WARNING: No connection is to be
made to the earth terminal.
; the maximum length is 30 m.
2
english
37