General Operation - ProMariner ProSport 1.5 Manuel Du Propriétaire Et Guide D'installation

G E N E R A L O P E R A T I O N
11
LED Status Center - Operation and Display
Blue AC Power LED:
Mode LEDs - Each LED will sequentially illuminate after previous mode.
Low/Charging:
Auto Maintain (Energy Saver Mode):
Average Voltage
14
13
12
Low/Charging
11
Illuminates when AC power in present.
Red LED will be solid red during charging.
Green LED illuminates when batteries are
fully charged and being monitored to
automatically maintain your battery until
you are ready to use it.
Auto Maintain
Typical Portable Set Up with DC Clamps for In-Vehicle
Maintaining - Negative Chassis Ground
WARNING - Read and Follow all INSTRUCTIONS. FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE SERIOUS INJURY, DAMAGE OR EXPLOSION, ALWAYS WEAR SAFETY GLASSES.
Read and follow all General and Personal Safety Precautions in this manual and those
by the battery manufacturer.
Read and follow all the preparing to charge steps for in a vehicle battery charging.
Below please find the typical steps for in a vehicle charging NEGATIVE (NEG, N, – ) chassis ground vehicles.
a. Connect the RED POSITIVE (POS, P, +) cable clamp to the POSITIVE (POS, P, +) post.
b. Connect the BLACK NEGATIVE (NEG, N, – ) cable clamp to the vehicle's chassis. Do not connect
the black negative (NEG, N, – ) cable clamp to metal fuel lines or anywhere in proximity of the
carburetor or the battery itself.
c. Plug the charger into a properly grounded fault protected outlet.
d. When charging is completed always disconnect AC power, remove clip from vehicle chassis
and then remove clip from battery terminal.
G E N E R A L O P E R AT I O N
12