SPARKY HD Professional SM 1212CES Plus Notice Originale page 10

WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
PREPARATION fOR OPERATION
DUST EXTRACTION
WARNING: It is obligatory to connect
the sander to a M-class vacuum cleaner prior
to operation.
Using dust bags or filters inappropriate to col-
lect the dust separated during dry sanding will
increase the dust particles in the air. Over a pro-
longed period the high dust concentration in the
air may damage operator's respiratory system.
CONNECTING TO A VACUUM CLEAN-
ER
Insert a special dust bag for collecting the dust
separated during dry sanding into the vacuum
cleaner according to the instructions supplied
with the vacuum cleaner.
Pass the hose through the clamp (6).
Connect the hose (24) of the vacuum cleaner to
the dust extraction port (10) positioned on the
guard (11).
We recommend using this power tool with
SPARKY vacuum cleaners to achieve optimum
results in collecting the dust generated during
operation.
USING AUXILIARY ACCESSORIES
The power tool is delivered with the clamp (6)
mounted to facilitate you.
This accessory is designed for additional fas-
tening of the vacuum cleaner hose to the power
tool.
The clamp (6) is mounted to the driving machine
(4).
Fasten the vacuum cleaner hose to the clamp (6).
As the clamp (6) is intended for a certain type of
hose in some cases the hose may move in the
clamp (24), in other cases it is firmly fastened.
8
EN
This feature does not affect the power tool us-
age in any way.
SELECTING THE ACCESSORIES AND
PREPARATION fOR OPERATION
The selection of accessory depends on the in-
tended operation. Generally the permitted op-
erations with this power tool are the following:
- Sanding with sandpaper (18) or abrasive net;
- Cleaning with diamond disc (21);
- Fine sanding with sanding pads for dry fine
sanding max. Ø7" with hook-and-loop fasten-
ing.
Familiarise yourself with the instructions for
preparation for work with the corresponding ac-
cessory. Perform accurately the described pro-
cedures for mounting, replacement and remov-
ing the corresponding accessories.
SWITCHING ON - SWITCHING Off
The sander is secured against unintentional
switching on.
Switching on: Select the necessary speed by
rotating the electronic regulator (19). Move the
ON/OFF switch (5) forward.
Switching off: Move the ON/OFF switch (5)
backward.
ELECTRONIC SPEED PRE-SELECTION
The rotation speed can be varied smoothly by
turning the electronic regulator (19), positioned
on the rear of the sander.
The speed adjustment range varies from n =
240 min to 1250 min
-1
below:
Regulator position
A
B
C
D
E
f
G
The recommended regulator positions for the
different areas of applications are specified in
the table below:
SM 1212CES Plus ● SMА 1212CES Plus
according to the table
-1
Speed, min
240
400
570
740
910
1080
1250
-1