TP-Link RE450 V1 Guide D'installation Rapide page 9

English
4. Select your router's 2.4GHz/5GHz host network and enter the password, then click Next.
If your router does not support 5GHz wireless network, please click Skip to continue.
5. You can customize the Extended 2.4GHz and 5GHz SSIDs or use the same as your host network (default), then
click Next.
6. Verify your wireless settings and click Finish. Corresponding LEDs (2.4GHz/ 5GHz) should turn on and stay solid.
④ Relocate
1. Plug the extender into an electrical outlet about halfway between your router(Host Network) and the Wi-Fi
dead zone.
2. Wait until the
signal quality.
Choose a location away from Bluetooth devices and other household electronics, such as cordless phone,
microwave, and baby monitor, etc., to minimize signal interference.
2.4GHz Host Network
Region
Please select 2.4GHz Host network or skip this network.
SSID
Your router wireless name
Host 2.4GHz Password:
TP_LINK_123456
2.4GHz Host Network
Region
Extended 2.4GHz SSID: Your network name
The extended 2.4GHz password is the same as your Host password.
Extended 5GHz SSID: Your network name_5G
The extended 5GHz password is the same as your Host password.
LED is lit and solid blue. If not, relocate it closer to the router to achieve a good (or better)
Host Network
Ideal extender Placement
keep away from
5GHz Host Network
MAC Address
Signal
30:B5:C1:33:99:76
12345678
23:B5:C0:30:90:06
Back
5GHz Host Network
Hide SSID broadcast
Hide SSID broadcast
6
Wireless Settings
Summary
Security
Next
Other... Rescan Skip
Wireless Settings
Summary
Copy Host SSID
Copy Host SSID
Back Next
Extended Network