TP-Link RE450 V1 Guide D'installation Rapide page 10

Enjoy!
Both extended networks share the same Wi-Fi password as your host network, but may have different wireless
network names if you customize the names during the configuration.
Option 2 Using WPS (Wi-Fi Protected Setup)
Please use Option 1 if your router does not support WPS.
① Power on
Plug the extender into an electrical outlet near your router, and
wait until the Power LED is lit and solid blue.
② Connect
1. Press the WPS button on your router.
For more information about using WPS
on your router, please refer to the router
manufacturer's user guide.
③ Relocate
1. Plug the extender into an electrical outlet about halfway between your router(Host Network) and the Wi-Fi
dead zone.
2. Wait until the
signal quality.
LED is lit and solid blue. If not, relocate it closer to the router to achieve a good (or better)
Host Network
Ideal extender Placement
2. Press the button on your extender.
If the LED is on, but only 2.4GHz/ 5GHz host
network is connected, please refer to the FAQ > Q2.
Extended Network
7
The LED should change
from blinking to a solid state,
indicating that WPS connection
was successful.
If not, please use Option 1.
English