Maintenance - Hoover POWERDASH FH13010PC Mode D'emploi

Maintenance

How to Empty and Clean your Tanks
Dirty Water Tank
1
Turn the cleaner off and
unplug from electrical
outlet.
2
Press latch and remove Dirty
Water Tank from the back of
the unit.
3
Carry Dirty Water Tank in
an upright position and
place on a flat surface.
10
WARNING:
Risk of personal injury - Brush
roll may suddenly restart. Turn power switch off
and unplug before cleaning or servicing.
4
Open Quick Pour Spout and
empty.
5
Replace and close the Quick
Pour Spout.
6
Prior to replacing tank, check
and clean filter as needed.
7
Replace Dirty Water Tank by
tilting back then rocking it
forward to snap into place.
If appliance is not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, take it to a service center or
call customer service at 1 (800) 944-9200 prior to continuing use.
Clean Water Tank
1
Remove tank from the
unit.
2
Unscrew cap. Empty
tank, rinse and allow
to air dry.
3
Replace the tank once
it is clean and dry.