Télécharger Imprimer la page

Ooni 3 Manuel page 14

Publicité

Les langues disponibles

Les langues disponibles

Gas Safety Information
The appliance must be installed at least 1 meter from any flammable materials.
The oven should be placed on a non-flammable, stable and flat surface.
Make sure your oven is placed in an area that will not be affected by adverse weather.
When the diameter of the injector is 0.83mm use the provided 28mbar regulator with Propane LPG
cylinder.
Appliance only to be used with Propane LPG. Minimum cylinder capacity 4kg maximum cylinder capacity
13kg.
Use a suitable provided regulator certified to AS 4621 and a flexible hose certified to AS/NZ 1869.
The length of the hose must be no more than 1.5 meters. Worn or damaged hose must be replaced. Ensure
that the hose is not obstructed, kinked, or in contact with any part of the oven other than at its connection.
The gas supply hose should be checked periodically and should be replaced if damaged and at least
every two years.
Check all connections for gas soundness.
Your country's national requirements will advise you how often to replace the hose. Regularly review
these requirements for your country.
In the case of blocked venturi immediately turn off burner unit, turn off gas supply, disconnect gas supply
and wait until cooled to removed from oven.
Ensure the appliance is clear of debris before every use. If any debris does build up use a brush to remove
this when appliance has cooled.
AUS
POL gas regulator
This is an anticlockwise threaded gas
fitting. Ensure the tank is fully turned off
and screw the regulator on to the gas
tank valve fitting until tight.
12

Publicité

loading

Produits Connexes pour Ooni 3