Qlima LK 5010 Manuel D'utilisation page 53

E-Cooling function: A special semiconductor material forms the thermocouple to
produce the Peltier effect, which is a new type of refrigeration method. It keeps
cooling the water automatically in the tank to reduce the water temperature.
Sliding door design: modern design of sliding door when the unit is switched on
or off.
Function Operation
• Ensure the unit is in the (OFF) position before plugging into the mains power
socket.
• Place the unit on a firm level surface.
• Avoid overloading the circuit by not plugging other high wattage products
into the same mains power socket
Plug into the mains power socket, the power indicator lights up, the Device is on
power, and shows the temperature.
ON/OFF
SPEED
SUPER
COOLER
Press this button to turn on the unit at low speed
the temperature . The door of the unit slides down to the
bottom automatically.
Press it again to turn off the unit. The door of the unit slides up till
completely closing.
Press this button to switch the unit between LOW
HI Speed, in normal mode.
Press this button to turn to the max wind air.
Press it again to turn to original wind setting.
When the unit is running by this function, the pump and the
E-cooling system is working at the same time. The water is
pumping from the water tank and flowing through the electronic
refrigeration cooling system (Called Semiconductor), and going
inside to the water curtain to achieve the effect of cooling.
Press this button again to turn off the function.
** For much better cooling effect, ice box or ice is recommended to
be put in the water tank.
Caution: there is water shortage warning, if the water is not
enough, the COOLER function will automatically stop, and 3 beeps
will be heard, and the display of the cooler will be blink.
.
, and display
– MID -
4
53