Qlima LK 5010 Manuel D'utilisation page 54

WIND
TIMER
ION
SWING
CLEANING AND MAINTENANCE
1.
2.
3.
4.
5.
6.
1.
2.
3.
4
54
Press to select Normal Mode, Natural Breeze Mode or Sleep Mode
(as indicated on the Display).
NORMAL Mode: The unit operates at the speed selected with
"ON/ OFF" button.
NATURAL BREEZE Mode: Fan speed varies automatically to simulate
a breeze*.
SLEEP Mode: Fan speed varies automatically for use during sleep*.
When the unit is in use, you can set the Timer to turn off the unit
after the specified time. Press this button repeatedly to increase
the Timer setting in 1 hour increments (up to a maximum of 9
hours) as indicated on the display. After 5 seconds, the Timer starts.
Once the Timer has run out, the unit will turn off.
Press this button to turn the Ionizer feature on/off (the unit must
be operating for Ionizing to work).
When the ioniser is turned on, it will assist in the purification of the
room air.
Press this button to start Fan Oscillation with left and right direction.
Press it again to stop Oscillation.
Unplug the unit before cleaning.
Clean the cooling master when it is visibly dirty or every month (depending
on the condition of the surroundings).
Dry the honeycomb after using to avoid mildew; Replace and clean the water
regularly to keep water clean. Use a dry cloth to absorb the remaining water
inside the tank, and dry it with a piece of soft cloth;
Clean the water tank, filter mesh every two weeks.
Clean the unit and honeycomb two weeks one time as following steps:
Pack this unit properly and store it in a cool dry place if it is not used for a
long period.
picture 4
Take out the rear net first as indicated in the arrow direction, picture 4.
Take out the water curtain as shown in the arrow direction, picture 5.
Clean the water tank at the same together with the rear net and water
curtain.
picture 5