Publicité
Les langues disponibles
Les langues disponibles
3 HOLE INSTALLATION NO SIDE SPRAY
5
5A
BOTTOM GROOVE
5 INSTALLING DECKPLATE
Ensure that the Plastic Putty Plate (5A) is pressed on the Deckplate (5B). Place
a bead of plumber's putty in the groove along the outer edge of the Putty Plate
(5A). Install the Deckplate (5B) over the three holes in your sink.
6
6C
6A
6 SECURING DECKPLATE TO DECK
From underneath sink, hand tighten Wing Nuts (6A) to Mounting Posts (6C).
Caution: do not over-tighten wing nuts. Remove any excess putty from
around the outside edge of Deck Plate (6B).
STOP
3 HOLE INSTALLATION WITH SIDE SPRAY
7
7A
BOTTOM GROOVE
7 INSTALLING DECKPLATE
Ensure that the Plastic Putty Plate (7A) is pressed on the Deckplate (7B). Place
a bead of plumber's putty in the groove along the outer edge of the Putty Plate
(7A). Install the Deckplate (7B) over the three holes in your sink.
8
8A
8B
8D
5B
6C
6B
6A
Go To Step 17
7B
8A
8D
8G
8E
ENGLISH
8 SECURING DECKPLATE & HOSE GUIDE
Insert Hose Guide (8A) into the side hole in the Deckplate (8B) and onto the
sink hole. Align the hose guide Tabs (8C) to those in the Deckplate Hole (8D).
From underneath sink, secure the Hose Guide (8A) by screwing the Plastic
Locknut (8D). Secure Deckplate (8E) by screwing Wing Nut (8F) to Mounting
Post (8G). Hand tighten. Caution: do not over-tighten. Remove any excess
putty from around the outside edge of Deckplate (8E).
9
9 SIDE SPRAY INSTALLATION
Insert the Side Spray Hose (9A) through the Hose Guide (9B). From underneath
sink, feed the Side Spray Hose (9A) back up through the center hole of sink
and through Deckplate (9C) so that it is above the sink.
10
10 INSTALLING MOUNTING RING & GUIDE FLANGE
Place Mounting Ring (10A) over Plastic Gasket (10B) and sink hole. If desired,
place a small bead of plumber's putty to the underside of the Hose Guide Flange
(10C). Align both Mounting Ring (10A) and Hose Guide Flange (10C) to the
center of sink holes.
11
8C
8B
11 SECURING HOSE GUIDE
8F
Insert Hose Guide (11A) into Hose Guide Flange (11B) and onto the sink hole.
From underneath sink, secure the Hose Guide (11A) by screwing the Plastic
Locknut (11C). Hand tighten.
3
9A
9B
STOP
Go To Step 16
2 HOLE INSTALLATION
10C
11A
11B
9C
10A
10B
11C
Publicité
