Broan-NuTone PM390 Serie Instructions page 3

and green to green.
4. Replace wiring box cover and screws. Make sure that wires are
not pinched between cover and box.
WIRING BOX
OPERATION
Controls
The light switch turns the lamps on and off.
The blower switch: makes it possible to select the motor operating
speed. Position 0: motor off.
The pilot lamp lights up whenever the blower is on.
LIGHT
SWITCH
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE
CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
Grease Filter
The grease filter should be cleaned frequently. Use a warm detergent
solution. Grease filter is dishwasher safe.
To remove the grease filter: remove the grid by moving the 2 slide
fasteners "A" (Fig. 2); remove the metal wires and then the grease
filter (Fig. 9).
GREASE FILTER
Non-Ducted Recirculation Filter
The Non-Ducted Recirculation filter should be changed every 6
months.
To remove the Non-Ducted Recirculation filter:
1. Remove the grid by moving the 2 side fasteners "A" (Fig. 2).
2. Remove the metal wires (Fig. 6) and replace the Non-ducted
recirculation Filter.
Cleaning
Occasional care will help preserve its fine appearance.
• Clean with warm water and mild detergent only.
• Follow all cleaning by rinsing with clear water.
• Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two 40-Watt light bulbs (not included).
To change bulbs:
1. Remove the grid by moving the 2 slide fasteners (A).
2. Replace with light bulbs of the same type (MAX 40W, 120V,
Candelabra Base Bulb). CAUTION: BULB MAY BE HOT!
BLOWER
SWITCH
PILOT LAMP
METAL WIRES
SERVICE PARTS
KEY NO. PART NO.
4 B03295083
5 B03118154
6 B02011013
9 B08087922
14 B02300233
27 B02011155
28 B02300280
29 B03293051
45 BW0000043
48 B02310203
49 B03295076
86 B08088378
FIG. 7
115 BE3334250
116 BE3334252
134 B03295084
152 B03292200
165 B03294780
165 B03295008
196 BE3348672
222 B03295080
223 B03295082
228 B08086263
229 B03201014
241 B03295081
472 BE3344843
998 B080810782
CAS B06002125
AQI B06108607
-
FIG. 8
- B08999040
FIG. 9
DESCRIPTION
Side Fastener
Grid
Spring
Grease Filter
Condenser
Metal Wires
Lampholder
Light Fitting
Blower
Motor
Blower Wheel
Damper
Wiring Box
Wiring Box Cover
Grid Stop
Wire Clamp
Controls Box
Box Condenser
Reflector
Control Box Cover
Blower Switch
Controls Board
Pilot Lamp
Light Switch
Controls Bracket
Hardware Package
Blower Assembly (Included
Key No. 45, 48, 49)
Switch box Assembly
(Included Key No. 165, 228,
28, 222, 152, 241, 223, 229)
- "40 Watt Max.Candelabra
Bulbs not included"
Non-Ducted Filter Kit
(purchased separately)