EHEIM classic 1500XL Mode D'emploi page 13

English
Filter compound formation, from base upwards:
Install EHEIM FIX or EHEIM MECH to a depth of approx. 3 – 5 cm as the lowest filtration layer.
Fill the accompanying net bag with EHEIM SUBSTRAT or EHEIM SUBSTRATpro or EHEIM LAV, as the
main mechanical-biological filtration compound, and install in the filter canister. The net bag fa-
cilitates subsequent handling for cleaning operations.
Install approx. 3 cm EHEIM FIX as the top layer. Except when carrying out short-term filtering after ad-
ding medication, please do not use cotton wool, which soon becomes clogged with the high flow
rate through the filter.
Charcoal is only advisable for short-term use if it is necessary to filter out unwanted substances when
the filter is new or after the addition of medication. It should be replaced by the specified filtercompound
formation after a maximum of 3 weeks. Never re-use old charcoal.
E Pressure side installation:
Secure the jet pipe to the rear aquarium panel with the aid of the two suction pads, at a sufficient di-
stance from the surface to ensure good oxygenation (1) or surface movement (2), depending on type
of installation. The outlet elbow should be secured to the jet pipe with a short piece of hose, the elbow
being led over the edge of the aquarium. Connect the outlet elbow and pressure side union of the
filter with hose.
F Place the filter below the water level, ideally beneath the aquarium. Take care to ensure that the pump
receives sufficient ventilation.
Suction side installation:
Fit the intake pipe and strainer together, connect the elbow with a short piece of hose and secure the
intake pipe assembly to the aquarium panel with 2 suction pads. Connect the elbow to the inta-
ke side hose connector on the filter with hose.
6. Putting into operation
Release the pressure hose from the jet pipe. By suction on pressure side (or using the EHEIM suction
device, order no. 4003540), draw water through the end of the hose and over the rim of the aqua-
rium until the filter is functioning fully of its own accord. Now reconnect the pressure hose to the jet
pipe and switch on the filter by plugging it into the power supply.
7.
Servicing and maintenance
G Always disconnect the power supply before carrying out any cleaning or other operations on the filter.
To clean the filter, pull off the hose from the intake pipe and empty the Filter container into a bucket or
allow it to drain. Then, and only then, remove the filter cover. Remove filter compound (clean or replace)
and clean the appliance. For the care of the centrifugal pump, refer to the accompanying pump instruc-
tion leaflet.
The filter canister on model 2260/2262 can be emptied direct by attaching a hose to the drain tap, if requi-
red.
Cleaning of the pump:
Remove the connection bend, unlock the pump lid and remove all parts as shown on the drawing. Clean
the pump pipes with a set of cleaning brushes (order no. 4009560). Clean the pump parts under running
water and then reassemble in the same order.
H Diagram showing assembly of the safety hose.
Note: All hose connections must be checked at regular intervals for correct fitting.
13