Publicité
Les langues disponibles
Les langues disponibles
1.
Switch off the mains.
2.
Disconnect the thermostat supply cord from the socket or connector block (be careful not
to leave the power supply leads uncovered).
3.
Loosen the hex screw on the back of the thermostat.
4.
Remove the thermostat from the heating element connection and disconnect the electric
wiring.
WARNING - After the thermostat has been uninstalled it cannot be reused. Replace with a new one.
TECHNICAL SPECIFICATIONS
Maximum power output.
Working temperature
Storage temperature
Working humidity
IP protection level
Insulation class
Material
Dimensions
Weight
Manufacturer: DELTACALOR s.r.l.
Instruction manual available from:
http://www.lfantoni.com/d/DOC.IS.003676.pdf
The
symbol applied to the product means that it is compulsory to consign the appliance to
a special waste collection centre in case of disposal, in conformity to the 2012/19/UE Directive.
The appliance may also be returned to the dealer if it is being replaced. This product is not in-
cluded in the ordinary domestic waste category. A correct waste disposal implies protecting the
environment and limiting exploitation of natural resources.
Declaration of conformity: The manufacturer hereby declares, under own ex-
clusive responsibility, that the product subject to this manual satisfies the essen-
tial requirements of Low Voltage Directives 2014/35/UE, CEM 2014/30/UE and
RoHS 2011/65/UE.
HOW TO UNINSTALL
Qualified technicians only.
1500 W
0-50°C
-20 ÷ +70°C
0-80% without condensation
IP44
Class I - Class II (only when assembled with the radiator
body)
ABS Bayblend
63×63×56 mm
170 g
[ 22 - EN ]
Publicité
