Troubleshooting
PROBLEM
Microwave oven
interfering with radio,
TV or similar equipment.
Dim microwave
oven light.
Steam accumulating
on door and hot air
coming out from vents.
POSSIBLE PROBLEM
Microwave oven
will not start.
Microwave oven
does not heat.
Glass turntable makes
noise during operation.
LCD time digit shows
EA1A then V1:00 or
similar information then
goes to default mode.
LCD time digit shows
00 for a short period
of time then shows 1 or
0 and stays at 1 or 0.
EASY SOLUTION
•
Clean door and sealing surface of the oven.
•
Reorient the receiving antenna of radio or television.
•
Relocate the microwave oven with respect to the receiver.
•
Move the microwave oven away from the receiver.
•
Plug the microwave oven into a different outlet so that microwave oven and
receiver are on different branch circuits.
•
When operating on low power levels, the microwave oven light may
be dimmer.
•
During operation, steam may be produced. Most will exit through the
vents, however some may accumulate around the oven door.
POSSIBLE REASON
•
Power cord not plugged
in properly.
•
Fuse blown or circuit
breaker problem.
•
Trouble with outlet.
•
Door not
closed properly.
•
Turntable roller not
assembled properly or
needs to be cleaned.
•
Both A BIT MORE™
& SMART REHEAT
button are pressed at
the same time under the
default mode.
•
Both A BIT MORE™
& SMART REHEAT
button are pressed at
the same time under the
default mode.
EASY SOLUTION
•
Unplug, put the plug in again and switch on.
•
Replace the fuse or reset circuit breaker.
•
Have a professional check that the outlet is
not faulty.
•
Ensure door is shut properly.
•
Reset and clean if necessary.
•
No action required. This is normal and LCD
just shows the model type and software
version.
•
If the LCD time digit stays at 0, send the unit
back to repair.
•
If LCD time digit stays at 1, Press STOP/
CLEAR to set the unit back to default mode.
35