Lincoln Electric POWER MIG 210 MP 12185 Manuel De L'opérateur page 8

RECOMMENDED
PROCESSES AND
EQUIPMENT
RECOMMENDED PROCESSES
The Power MIG ® 210 MP is recommended for GMAW, FCAW, GTAW,
and SMAW processes. The machine can support 4 inch and 8 inch
spools of wire for GMAW and FCAW welding. The machine is intended
for the following wire diameters and composition; Innershield NR-
211 ® .030 - .045 self-shielding electrode and NR-212
shielding electrode, .035 Outershield 71M FCAW-GS, SuperArc L-56
.025" through .035" solid steel, .030 & .035" stainless MIG wires,
and SuperGlaze .030" through .035" aluminum. The machine is also
intended for GTAW welding with 1/16 and 3/32 tungsten and SMAW
welding with 3/32, 1/8 and 5/32 electrode.
PROCESS LIMITATIONS
Welding aluminum requires use of the Magnum Pro 100SG Spool
Gun.
EQUIPMENT LIMITATIONS
The Power MIG ® 210 MP is capable of MIG welding up to 200
amperes of current at 24 VDC, this output can be achieved at a 25%
duty cycle based on a ten minute cycle time with the machine
connected to 230VAC input. The machine is capable of higher duty
cycles at lower output currents or higher amperages at lower duty
cycles. The machine can be connected to either 230VAC @60Hz or
120VAC @ 60Hz. The output of the machine is limited when the
machine is connected to 120VAC input, details regarding the rating
when the machine is connected to 120VAC can be seen on the rating
plate.
Locate the welder in a dry location with free circulation of clean air
into the back. A location that minimizes the amount of smoke and dirt
drawn into the rear louvers, will reduces the probability of dirt
accumulating and blocking air passages which can cause
overheating.
TEMPERATURE RANGES
OPERATING TEMPERATURE
STORAGE TEMPERATURE
® .045 self
-4°F TO 104°F (-20C TO 40C)
-40°F TO 185°F (-40C TO 85C)
COMMON EQUIPMENT PACKAGES
BASIC PACKAGE:
CODE 12630
K3963-1
K520
K2275-1
K3071-1
K2528-1
KP4140-1
K3269-1
K1782-6
K960-1
KP508
K4104-1
K870
K2265-1
All three items required for TIG Welding
Includes Everything required to start TIG Welding.
Foot Amptrol & Adapter not included.
8
PRODUCT DESCRIPTION
DETAILS
• WIRE-FEEDER-WELDER
• GROUND CABLE AND CLAMP
• ELECTRODE HOLDER AND CLAMP
• SAMPLE SPOOLS OF WIRE
• MAGNUM PRO 175L GUN
• GAS REGULATOR AND HOSE
• SPARE CONTACT TIPS
• DRIVE ROLLS AND WIRE GUIDES
• SPINDLE ADAPTER
UTILITY CART (150 CU FT. BOTTLE CAPACITY)
WELDING CART (80 CU FT. BOTTLE CAPACITY)
CANVAS ACCESSORY BAG
INNERSHIELD WELDING KIT
REPLACEMENT SCREEN SHIELD
MAGNUM PRO 100SG SPOOL GUN
PTA-17V UltraFlex Torch 12.5'
Twistmate Adapter
Torch Accessory Kit
Foot Amptrol Adapter
Foot Amptrol
TIG MATE TIG STARTER PACK