Safety Instructions And Disclaimer - APLIC 302656 Manuel

Error
Speed is not
displayed or
displayed
incorrectly
11 Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid
contact with mains voltages. Do not short-circuit the product. The de-
vice is not certified for use in the open air; only use it in dry conditions.
Protect it from high humidity, water and snow. Keep it away from high
temperatures. Do not subject the device to sudden changes in tem-
perature or heavy vibration as this might damage electronic compo-
nents. Examine the device for damage before using it. The unit should
not be used if it has received an impact or has been damaged in any
other way. Please observe national regulations and restrictions. Do not
use the device for purposes other than those described in the instruc-
tions. This product is not a toy. Keep it out of the reach of children or
mentally impaired persons. Any repair or alteration to the device not
carried out by the original supplier, will invalidate the warranty or gu-
arantee. The product may only be used by persons who have read and
understood these instructions. The device specifications may change
without any separate prior notice to this effect.
12 Disposal instructions
Electrical and electronic devices may only be disposed of in accordance
with the European WEEE Directive and not with household rubbish.
Components must be disposed of or recycled separately as dange-
rous, toxic elements can inflict sustained damage on the environment
English
Cause of error
• Distance
between magnet
and sensor is too
much
• Sensor not
mounted
properly
• Configured wheel
circumference is
incorrect
Troubleshooting
• Reduce the distance
between magnet and
sensor
• Check the sensor
position and adjust if
necessary
• Measure the wheel
circumference again
and correct it
31