Initial Use - APLIC 302656 Manuel

Installing the transmitter (wireless)
Glue the long foam plate to the inside of the transmitter and place
it on the wheel fork. Fix the sensor using the cable ties provided.
The sensor side of the transmitter should point towards the spokes.
Ensure that the sensor makes contact with the spokes.
Installing the magnet
Unscrew the magnet from the magnet holder. Then place the plastic
plate with the guide at the top in a spoke. Screw the magnets and the
nut onto the plastic plate so that the spoke is tightened.
Note: The minimum distance between the magnet and transmitter
should be less than 5 mm to ensure optimum transmission. Adjust the
magnet accordingly.

5 Initial use

The system is completely reset when you replace the battery. We
recommend you to reset the device once before using it. To do this,
remove the battery and insert it again.
22
English