Panasonic K1 Mode D'emploi page 21

Cleaning the main unit and remote controller
● Wipe clean using a soft, dry cloth.
● To remove stubborn dirt, moisten a cloth in warm water no
hotter than 40 °C, wring thoroughly, and then wipe.
● The front panel can be removed in order to wash it with
water.
Removing and remounting the front panel
Removing
Open the front panel until it is nearly horizontal, grasp the
sections near the front panel arms on both sides, and then
remove the panel by pushing the arms towards the outside
while pulling the panel towards you. If the front panel is difficult
to remove, grasp both ends of it and lift it up slightly. Move it to
the left and disengage the left arm, then move it to the right and
disengage the right arm.
Front panel
CAUTION
● Certain metal edges and the condenser fins are sharp
and may cause injury if handled improperly; special care
should be taken when you clean these parts.
● Periodically check the outdoor unit to see if the air outlet
or air intake is clogged with dirt or soot.
● The internal coil and other components must also be
cleaned periodically. Consult your dealer or service
center.
Care: After a prolonged idle period
Check the indoor and outdoor unit air intakes and outlets for
blockage; if there is a blockage, remove it.
Care: Before a prolonged idle period
●
Operate the fan for half a day to dry out the inside.
●
Disconnect the power supply and also turn off the circuit
breaker.
●
Clean the air filter and replace it in its original position.
●
Outdoor unit internal components must be checked and
cleaned periodically. Contact your local dealer for this
service.
Arm
21
■ When Using Wireless Remote Controller Instead of
Wired Remote Controller
Wall Mounted (K1 Type)
When the wireless remote controller is to be used, slide the
switch (S011) on the indoor unit control PCB to the ON position.
● If this setting is not made, an alarm will occur.
(The operation lamp on the display blinks.)
Setting status
ON: Wireless: main, Wired: sub
OFF: Wired: main, Wireless: sub (at shipment)
Slide