Manuels Connexes pour Alt VIA DANTE 70722
Sommaire des Matières pour Alt VIA DANTE 70722
- Page 1 VIA DANT E 7 0 72 2 Pressure balance trim kit with cartridge and handle Garniture pour valve à pression équilibrée avec cartouche et poignée Installation & Care Guide Guide d’installation et d’entretien last revision: 16/03/2021...
- Page 2 Félicitations pour l’achat de purchase of your Alt product votre produit Alt By purchasing an Alt product, you are taking part in En achetant un produit Alt, vous prenez part au the global movement for better living. We take pride in mouvement global pour le mieux-vivre.
- Page 3 TRIM KIT COMPONENTS COMPOSANTES DE LA GARNITURE SPECS AT LARGE / SCHÉMA DES PIÈCES ALT7-60-668-01: handle / poignée ALT7-60-848-01: Trim plate+screw / plaque+vis ALT7-CTCB-0185-01: Dome cap / Capuchon en dôme ALT7-60-699-00: cartridge / cartouche (since summer 2016) ALT7-60-697-00: cartridge / cartouche (before summer 2016)
- Page 4 BEFORE YOU START AVANT DE COMMENCER CAUTION: FOR BEST RESULTS, WE STRONGLY MISE EN GARDE: POUR OBTENIR UN RÉSULTAT RECOMMEND THE INSTALLATION OF THIS VALVE BE OPTIMAL, NOUS RECOMMANDONS FORTEMENT QUE DONE BY A LICENSED PLUMBER. L’INSTALLATION DE CETTE VALVE SOIT FAITE PAR UN PLOMBIER ACCRÉDITÉ.
- Page 5 INSTALLATION Installing the cartridge First, verify the 2 check-valves (1) & (2) are shut off. Afterwards, unscrew the cartridge holder (4) and re- move the protective plug (3) (see Fig.1) . Insert the cartridge into the valve body as shown (Fig.2). Screw the cartridge holder (4) back into place.
- Page 6 INSTALLATION Installing the trim kit Insert the decorative sleeve (6) onto the cartridge holder (See Fig.3) then screw the dome cap (5) onto the valve body. Slide in trim around the valve body and press it firmly against the wall. Make sure the trim is properly aligned with red marking (HOT water) on the left and blue marking (COLD water) on the right.
- Page 7 INSTALLATION Water temperature adjustment The preset temperature can be adjusted by following these steps: Remove the setscrew (2), the volume control handle (1) and the dome cap (3). (See Fig.4). Pull out the temperature stop ring (4) from the cartridge (5).
- Page 8 MAINTENANCE To Service The Cartridge Remove all the components from (1) to (6). (See Fig.5). Afterwards, shut off the 2 check valves (9) by turning them clockwise with a screwdriver. Unscrew the car- tridge holder (7) and remove the cartridge (8). To clean the cartridge, you may need to soak it in a vinegar and water solution to remove lime build-up.
- Page 9 CARE SOIN To clean your ALT faucet or accessory, wash with a Pour nettoyer et conserver l’apparence de vos robinets ou accesoires ALT, lavez-les avec un linge wet nonabrasive soapy cloth. Then wipe dry with a mouillé à l’eau tiède et enduit d’un savon doux soft towel or cloth.
- Page 10 This warranty is in lieu of and excludes all other warranties, conditions ALT se réserve le droit de modifier les spécifications de ses produits sans avis ni and guarantees, whether expressed or implied, statutory or otherwise, obligation ainsi que de remplacer ou de retirer certains modèles.