Publicité
Les langues disponibles
Les langues disponibles
6
Installation and connection
In the event of problems,
•
contact the Authorized Service
Centre. To prevent any damage,
only remove the appliance from
its packaging at the time of
installation.
Preparing for installation
WARNING: This is a heavy
product; the hood should only be
lifted and installed by two or more
people.
Electrical Requirements
Observe all governing codes and
ordinances.
Ensure that the electrical installa-
tion is adequate and in conformance
with National Electrical Code, ANSI/
NFPA 70 (latest edition), or CSA
Standards C22.1-94, Canadian Elec-
trical Code, Part 1 and C22.2 No.
0-M91 (latest edition) and all local
codes and ordinances.
If codes permit and a separate
ground wire is used, it is recom-
mended that a qualified electrician
determine that the ground path is
adequate.
A copy of the above code standards
can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
A 120 volt, 60 Hz., AC only,
•
15-amp, fused electrical circuit
is required.
Grounding Instructions
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
cord having a grounding wire with
a grounding plug. The plug must be
plugged into an outlet that is prop-
erly installed and grounded.
WARNING: Improper grounding
can result in a risk of electric shock.
Consult a qualified electrician if
the grounding instructions are not
completely understood, or if doubt
exists as to whether the appliance is
properly grounded.
Do not use an extension cord. If
the power supply cord is too short,
have a qualified electrician install an
outlet near the appliance.
If the house has aluminum wiring,
•
follow the procedure below:
Connect a section of solid
1.
copper wire to the pigtail leads.
Connect the aluminum wiring
2.
to the added section of copper
wire using special connectors
and/or tools designed and UL
listed for joining copper to alu-
minum.
Follow the electrical connector man-
ufacturer's recommended proce-
dure. Aluminum/copper connection
must conform with local codes and
industry accepted wiring practices.
Wire sizes and connections must
•
conform with the rating of the
appliance as specified on the
model serial rating plate.
The model/serial plate is located
behind the filter on the rear wall
of the range hood.
ENGLISH
Publicité
