Axis T93E05 Guide D'installation page 8

Page 8
Install the wall bracket
1. Use the supplied drill template to prepare a wall or pole for installation of the wall bracket.
2. Route a shielded network cable through the wall bracket. Leave approximately 12 cm (4.7") of
cable for connecting the camera.
3. Install the wall bracket on a wall or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
Install the camera on the bracket
Axis outdoor cameras
1. Loosen the bottom cover screws and open the top cover, see illustration on page 6.
2. Refer to the instructions in Axis indoor cameras installed in AXIS T93E05.
Axis indoor cameras installed in AXIS T93E05
1. Unscrew the cable gland nut and remove the gasket from the cable gland.
2. Route the shielded network cable through the cable gland.
Note: Always use a shielded network cable (STP) intended for outdoor use between the camera and
the end point and ensure that the end point is properly grounded. Installations of Axis
cameras using a shielded network cable (STP) and a properly grounded end point have been
tested to comply with industry immunity standards' levels such as surge protection. Any other
installation method will void the warranty and leave the unit at a risk.
3. Install the camera with the housing on the bracket and tighten the bracket screws.
4. Attach the gasket to the network cable and push the gasket back into the gland.
Bracket adjustment screw
Example image: AXIS M1114 Network camera and AXIS T93E05 Protective Housing
Network cable (route through wall bracket)
AXIS T93E05 User's Guide
Gasket
Wall bracket
Bracket screw (4x)
Cable gland nut
Rubber seal