Cleaning 2 - Merrychef Mealstream EC401 Mode D'emploi

CLEANING 2

Follow the SAFETY INSTRUCTIONS at the beginning of this manual.
• ALWAyS switch off at the electrical supply and allow oven to cool
for at least 20 minutes before cleaning
• As required, remove carousel and wipe out spillages with
disposable paper wipes
• NEvER use steel wool, knives or harsh abrasives on any part of
the oven
As with all electrical appliances, it is wise to have the electrical
connections inspected periodically.
Cleaning the oven cavity and door
DO NOT SPRAy ANy CLEANING FLuID DIRECTLy
INTO THE CATALyTIC CONvERTER vENT HOLES
AT THE REAR OF THE OvEN CAvITy.
THIS WOuLD CAuSE PERmANENT DAmAGE TO
THE CATALyTIC CONvERTER (Mealstream 403 )
. Remove trays, racks, turntable and turntable disc from the oven
cavity. Clean using non-caustic oven cleaner. Wash off using a clean
cloth and plenty of clean, warm water. Dry using a fresh, clean cloth.
Mealstream 403 Model only:
To remove the catalytic converter at the rear of the cavity undo the
three thumb nuts to release the cover plate and carefully lift out.
Wash the catalytic converter in CLEAN HOT WATER only, do not use
cleaning products which could cause permanent damage to the filter.
Leave to dry.
Clean the cover plate in non-caustic oven cleaner and dry using a
fresh clean cloth.
. Remove food particles from between the inside edge of the door and
the front of the oven floor using a clean, dry brush ( Location A ).
Apply non-caustic oven cleaner to interior surfaces except door seals
and leave for the recommended time. Wash off using a clean cloth
and plenty of clean, warm water. Dry using a fresh, clean cloth.
3. Wipe hinges with a clean, damp cloth.
DO NOT apply lubricating oil to hinges.
4. Wipe door seals carefully with a clean damp cloth.
Examine for signs of wear or damage.
5. Mealstream 403 Model only:
Replace the Catalytic Converter and cover plate ensuring the face of
the converter with the spacing edge is facing outwards to allow air to
pass efficiently through the filter.Tighten up the three thumb nuts.
Hints and Tips for stubborn stains in the oven cavity
. Switch on oven with microwave power only (without heat).
. Place a container of water (.5 litres) into the centre of the oven cavity.
3. Set microwave power to 00%.
4. Set timer to 30 minutes and press start button.
At end of steam cycle, wipe out cavity with a clean cloth.
6
Faults arising from neglect or
misuse including use without
clean filters in place are not
covered by the guarantee.
Service visits as a result of
such faults will be chargeable.
Hot surface
hazard
A
rear of oven
cavity
Catalytic
converter
Thumb
Nut
spacing edge
Merrychef recommends the use of
approved Merrychef Oven Cleaner
and Merrychef Oven Protector.
If the door seals are damaged
,the oven must be repaired by an
approved Service Engineer
DO NOT USE THE OVEN WITHOUT
A CLEAN AIR FILTER IN POSITION
Door
seal