Publicité
Les langues disponibles
Les langues disponibles
8134926manual
10/18/06
Prepare for work
1. Check and replace any damaged or worn parts
on the tool.
2. Place a few drops of pneumatic air tool oil
into the air inlet. If you use an automatic
inline oiler, check and add oil if necessary.
3. Make sure the magazine is empty of all
fasteners and the hose has an adequatley rated
work pressure, then connect the tool to the air
compressor.
4. Keep the tool pointed away from you and
others at all times. Do not load fasteners with
the trigger or safety depressed.
5. Regulate the air pressure to obtain 80 to 110
PSI, depending on working demands and the
workpiece.
6. Before loading the fasteners, disconnect the
tool from the air supply. Gripping the tool
firmly, pull the pusher back and engage the
latch.
7. Insert a strip of fasteners, keeping the point down (see fig 1.)
8. Orient and slide the strip of fasteners forward to the front of the magazine.
9. Release the latch and pusher, slide the pusher against the nails (see figure 2.)
Using the Tool
Wearing approved safety glasses and protection equipment to protect eyes and
ears, grip tool firmly, pointing the drive to the workpiece. Depress nosepiece
onto work surface, then squeeze trigger to fire a fastener. The amount of air
pressure required will vary, depending on the size of the fastener and the
material being fastened.
Excessive air pressure can cause premature wear and damage to the tool. Test
the driving depth in a sample piece of wood before use. If the fasteners are being
driven too far or not far enough, adjust the regulator to provide less or more air
pressure as required.
Complete all preparation steps before use. This model (8118309) is equipped
with a single or sequential fire trigger design, intended for intermittent nailing,
allowing accurate nail placement, as well as increased operator safety.
4:22 PM
Page 5
1
2
Publicité
