Use - Gourmet Maxx SW-2007DB Mode D'emploi

When the device is fi rst used, production-related additives (e.g. grease) may
cause a small amount of smoke and / or an odour to be produced. This is normal
and not a device defect.
6. Clean the device again (see the "Cleaning and Storage" chapter).

Use

PLEASE NOTE!
■ Do not overfi ll the device! Use no more than two eggs for egg dishes and recipes
requiring eggs! If you add too much food, it may overfl ow at the sides of the device
and make it impossible to open the device.
■ It should always be possible to close the device without too much effort. Do not open
or close the device with force!
Although the heating surfaces have a non-stick coating, we still recommend that
you lightly grease them before fi rst use. Do not use any cooking spray as it can
attack the non-stick coating!
1. Prepare the food as you wish. A few recipe suggestions can be found later on in these
instructions.
2. Open the lid (4).
3. Lightly grease the heating surfaces (1 + 2) before you fi rst use them.
4. Preheating: Insert the mains plug into a properly installed socket that is easily acces-
sible. The operating lamp (8) and the control lamp (3) light up and indicate that the
heating process has started. Keep the device closed during this process.
5. Once the device has reached its operating temperature (after approx. 3 – 4 minutes),
the control lamp goes out. Flip open the lid.
6. Pour the food into the mould of the lower heating surface. Make sure that you do not
pour too much food into the mould.
7. Carefully close the lid, press the handles together and fl ip down the catch. Allow the
food to fry until it is as brown as you want. During frying, the green control lamp may
go out and then light up again. This means that the device is heating up again in order
to maintain a constant temperature.
8. To release pressure, open the lid at least twice for a short time while cooking. Close
it again.
9. Towards the end of the cooking time, check whether the food is already cooked or still
needs to be fried for a little longer.
10. If the food is cooked, remove it carefully. To do this, use wooden or plastic kitchen
utensils so that you do not damage the non-stick coating.
11. To fry further food, repeat steps 3 to 9.
12. If no more food is to be baked, pull the mains plug out of the plug socket and allow
the device to cool down completely while open.
19 EN