VANTRUE OnDash N2 Pro Mode D'emploi page 14

A. Record Setup
Press the DOWN button and highlight the Record
Setup option. Press the OK button to enter the
settings, and use the UP/DOWN buttons to navigate
the different options.
-Resolution: By default (DUAL CAM RECORDING
mode), both cameras record at 1920x1080P (30fps).
In SINGLE FRONT CAM RECORDING mode,
2560x1440P (30fps), 2304x1296P (30fps), 1920x1080P
(60fps), 1920x1080P (30fps) options are available.
-Loop Recording: This is set to 3minutes per video
clip. Press OK to change the duration: 1,3, 5, or OFF.
-G-Sensor Set: Set to Medium by default. Pressing OK
gives the following sensitivity options: High, Medium,
Low, Off.
-Audio Recording: Default is ON. Press OK and
DOWN button to toggle it OFF/ON.
-Parking Monitor: Default is OFF. Press DOWN
followed by OK to toggle it OFF/ON.
-Front Camera Exposure: Default is Default is 0.
Pressing OK gives the following options: 0, -1.0, -2.0,
+2.0, +1.0
-Inside Camera Exposure: Default is Default is 0.
Pressing OK gives the following options: 0, -1.0, -2.0,
+2.0, +1.0
-Car Number Plate: Press UP/DOWN and OK to set
your car license number.
-Stamp: Default is ON. Press OK to toggle it OFF/ON.
Stamp shows the date/time, logo, car number,
Speed and GPS Location information.
-Rotate Display: Default is OFF. Press OK and DOWN
button to toggle it OFF/ON.
- 13 -