1618809_6093WideTrack.qxp_Layout 1 8/15/19 7:32 PM Page 4
Extension cords
ENGLISH
When using an extension cord with your unit, refer to the following
table to determine the required A.W.G. wire size. Before using the
cleaner, make sure the power cord and extension cord are in
good working condition. Make repairs or replacements before
using the vacuum cleaner.
NOTE: Only use extension cords that are rated for outdoor use.
Length of extension cord
25 feet
110V-120V
7.5 meter
Amps
0-6
18
7-10
18
11-12
16
13-16
14
Handle adjustment
• Using the wing nuts (Fig. 1), adjust the handle length to a
comfortable working position. Tighten all wing nuts.
• Loosen the handle lock levers (Fig. 2) on both sides of the unit
and adjust the handle to a comfortable operation height.
• Tighten the handle lock lever on both sides to lock the handle
in place.
Bag installation
ATTENTION
!
Never operate the unit without both the cloth bag
and paper bag.
• Attach the cloth zippered bag by placing the opening seal
securely around the neck of the exhaust opening (Fig. 3).
• Connect the snap from the bag to the exhaust frame (Fig. 4).
• Connect the 2 snaps in the front of the bag onto the top of the
unit (Fig 5).
• Unzip the cloth bag (Fig. 6) and install the paper bag inside
(Fig. 7).
• Attach the paper bag onto the vacuum exhaust opening (Fig. 8).
• Completely close the zipper of the cloth bag.
NOTE: To maintain optimum performance, change the paper bag
when it is nearly full or when suction diminishes.
4
50 feet
100 feet
150 feet
15.25 meter
30.5 meter
45.7 meter
A.W.G. wire size
16
16
14
16
16
14
16
14
12
12
Not recommended
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 6
Fig. 8
Fig. 5
Fig. 7